Results 1 to 2 of 2

Thread: Ideas: Show A Line Dividing Top From Bottoms

  1. #1
    Member
    Join Date
    2011-02
    Location
    Omaha, NE
    Posts
    12
    Login to Give a bone
    0

    Question Ideas: Show A Line Dividing Top From Bottoms

    As a drywaller I am participating in the BIM process along with MEP. A very important part of our process is "Topping Out" walls prior to MEP penetrations. Another part is getting full size sheets in that will stand above finished ceilings, Bottoms. It is to our advantage to have Med Gas, Elec. Conduit, Vac Tubes, etc. bends into walls above the break lines of bottoms and close to the start of tops. I want to create a break in the drywall of the wall type that shows this. Is there a better way to graphically display this other than doing just that. Breaking the board and creating a TOPS and BOTTOM gyp material defined in the wall type. I guess I could then assign a hatch to the TOPS. Do you guys have any better ideas? Have any other drywallers out there done this?

  2. #2
    I could stop if I wanted to Revitaoist's Avatar
    Join Date
    2009-11
    Posts
    380
    Login to Give a bone
    0

    Default Re: Ideas: Show A Line Dividing Top From Bottoms

    Select a wall and edit properties. Go to the edit structure button. Now open the preview flyout. Change the preview from plan to section. From here you can add sweeps, reveals, or splits with different materials and assign their height.
    Revit MEP Certified Professional

Similar Threads

  1. 2010: making all line segmentsof same line type show as one line segment
    By Darren Allen in forum AutoCAD LT - General
    Replies: 5
    Last Post: 2015-09-02, 10:35 PM
  2. Ideas/suggestions on Line patterns/styles ideas sanitary pipe
    By legolas1366 in forum Revit MEP - General
    Replies: 0
    Last Post: 2009-06-01, 05:35 PM
  3. Dividing line between 2 similiar materials in elevation
    By markklucas in forum ACA General
    Replies: 3
    Last Post: 2009-01-06, 05:12 PM
  4. Circles have tops and bottoms?
    By jgratton in forum AutoCAD 3D (2006 or below)
    Replies: 3
    Last Post: 2007-03-02, 02:30 PM
  5. Dividing line between two materials of the same type in elevation?
    By Steve_Bennett in forum ACA FAQ (Read only)
    Replies: 0
    Last Post: 2006-04-06, 06:58 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •