Blocks in Tool Palettes

[Li'l Crys]

Ok, my problem is this.

After inserting a block with attributes from Design Center, or the block library... right click=repeat block, or repeat library.

After inserting a block with attributes from a tool pallette...right click =repeat attribute dialoge box?

What is up with that?

[mjfarrell]

I wonder is this connected to your
ATTDIA command?

Are you entering the attribute values at time of insert?

[Li'l Crys]

I wonder is this connected to your
ATTDIA command?

Are you entering the attribute values at time of insert?

I don't think ATTDIA helps, I have experimented with it.

And yes, I am entering att values upon insert.

[mjfarrell]

Try this experiment

Use the tool pallette to plave an attributed block
hit ENTER or the space bar; what command is repeated?

Use the tool pallette to plave an non-attributed block
hit ENTER or the space bar; what command is repeated?

Do the same with ATTREQ set to zero.

Note your results.

[Li'l Crys]

Try this experiment

Use the tool pallette to plave an attributed block
hit ENTER or the space bar; what command is repeated?

Same thing, repeat dialogue box. (After placeing block, most recent commands are: ACDCATTEDIT & EXECUTETOOL)

Use the tool pallette to plave an non-attributed block
hit ENTER or the space bar; what command is repeated?

Repeats block.

Do the same with ATTREQ set to zero.

Note your results.

Repeats block but doesn't ask for Attributes