I am trying to finish a bi-fold door family. I can't seem to get the door panels to adjust correctly. See image below.
Family attached
|
|
|
I am trying to finish a bi-fold door family. I can't seem to get the door panels to adjust correctly. See image below.
Family attached
Here are a couple of families I did. Go ahead and use them if you'd like. You can reverse-engineer them to see how I built them. Also, the opening is an instance parameter. Have fun with them.
Assuming you are on V7 use reference lines. very easy with these.
Guy
Hi,
I am researching Bi-fold doors and came across your thread, however, the files mentioned are no longer attached. Is it possible to gain a copy of the Bi-fold doors mentioned?
Sorry, this thread went dormant so I deleted the files. Here they are again.