Results 1 to 2 of 2

Thread: Pipe Fitting and Accessories halftone an half size

  1. #1
    Member
    Join Date
    2011-07
    Posts
    5
    Login to Give a bone
    0

    Default Pipe Fitting and Accessories halftone an half size

    After getting an updated model from the Architect, my plumbing piping Fixtures and Accessories are halftone and probably half size in single line. Like it is not using the proper annotation size?

    Any thoughts? I checked the obvious VG/over-ride/MEP Setting, and everything seems as it was, no halftones selected.

    Thanks in advance

  2. #2
    Member
    Join Date
    2011-07
    Posts
    5
    Login to Give a bone
    0

    Default Re: Pipe Fitting and Accessories halftone an half size

    Additionaly, it I duplicate the view as a dependent, the fitting go back to looking normal.

Similar Threads

  1. Pipe fitting size TAG
    By Happyunited in forum Revit MEP - General
    Replies: 1
    Last Post: 2011-10-10, 05:24 PM
  2. Pipe fitting annotation size
    By RPOY in forum Revit MEP - General
    Replies: 2
    Last Post: 2010-09-28, 06:26 PM
  3. Pipe Size changes Fitting
    By cdsuggs in forum Revit MEP - Families
    Replies: 2
    Last Post: 2010-07-26, 09:32 PM
  4. Reducing Pipe Fitting Sizing Issue Based on Pipe Size
    By cdsuggs in forum Revit MEP - Families
    Replies: 0
    Last Post: 2010-07-22, 08:06 PM
  5. Size of Single Line Wye Pipe Fitting
    By i2mikee in forum Revit MEP - General
    Replies: 3
    Last Post: 2010-07-13, 08:11 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •