Results 1 to 1 of 1

Thread: Nvisworks Splitting Geometry into Surfaces

  1. #1
    Join Date
    Login to Give a bone

    Default Nvisworks Splitting Geometry into Surfaces

    Hey everyone. I am new here so please be gentle to the noobie. I am doing clash detection for the first time using Navisworks 2012. I am noticing that Navisworks is breaking apart the geometry into surfaces instead of solids (see attached). Is this normal? Did I miss a check box somewhere?

    The process: Architectural and Structural models are done in their respective Revit platforms. The structural is linked into the architectural. I exported the architectural model and the linked structural model together because the structural engineer did not use the shared coordinates.

    Any help or insight would be much appreciated.


    Attached Images Attached Images

Similar Threads

  1. 2014: Compare Surfaces/Report Surfaces Through XREFFED Models
    By Jeff@BOC in forum AutoCAD Civil 3D - Surfaces
    Replies: 6
    Last Post: 2014-04-24, 12:39 PM
  2. Geometry properties for surfaces objects
    By Wish List System in forum AutoCAD Wish List
    Replies: 0
    Last Post: 2013-10-27, 07:06 PM
  3. Modifying Geometry in ROBOT and Updating Geometry in REVIT
    By stephen.lewis in forum Robot Structural Analysis
    Replies: 7
    Last Post: 2009-12-09, 04:32 AM
  4. Nvisworks in Power Point
    By sarabia in forum NavisWorks - General
    Replies: 2
    Last Post: 2009-04-28, 05:50 PM
  5. Replies: 2
    Last Post: 2007-04-20, 05:37 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts