i want to show dedicated neutrals in a multi-circuit homerun. i am able to add conductor tick marks on a standard homerun wire, but as soon as i combine them, it grays out ability to add wires. i have unchecked 'Share Neutral Conductor' in the wire type properties, i thought that might force them to not share a neutral, and show each in the homerun, like it does for hot wires. does the same when trying to remove neutral conductors from a 3ph load, works fine, but when you combine 2 of those, it adds the neutrals back (both neutrals, by the way). i don't have 2017 installed yet, so haven't tested this in 17, but it hasn't worked right in any previous versions.
thanks,
mike