Hi All,
I am new to DB's and I am trying to get a stormwater pipe setup. I currently have a stretch and array chained, a lookup and an alignment. I have tried polar stretch with array too.
I need a gap near either end of the pipe and dashes arrayed along the length (currently just rectangles) and insert and end points at the centreline, with variable width. I would like to be able to modify the pipe easily if the spec changes.
Either way the block goes weird after a couple of changes. Also the lookup is inverted, ie a 375 pipe is narrow and 225 is wide. Any idea's what I have done wrong.
Thanks in Advance
Steve