I did a quick search through the forums and did not find anything already posted about this.
I'm in Revit MEP 2011, and I want to apply a view Filter to conduit runs below a particular diameter. I am using the "Size" system parameter in the filter so that I can apply it to both Conduit and Conduit Fittings.
In the Filter Rules:
Filter by: Size
is less than
1.5
I placed two conduit runs, one whose Size parameter 1 1/2" diameter for both the Conduit objects and the Conduit Fittings, and another at 1 1/4" diameter.
The filter seems to either apply or not apply to both runs, regardless of what number I enter in the filter. The filter applies for any value I enter down to 1.1. When I set the number to 1, the filter no longer applies to either run.
I asked around the office, and everyone agreed that 1 < 1.1 < 1.25 < 1.5
Am I doing something wrong?
Thanks in advance.