Results 1 to 3 of 3

Thread: view filter for conduit size

  1. #1
    Member
    Join Date
    2015-11
    Location
    Baltimore, MD
    Posts
    46
    Login to Give a bone
    0

    Default view filter for conduit size

    I did a quick search through the forums and did not find anything already posted about this.

    I'm in Revit MEP 2011, and I want to apply a view Filter to conduit runs below a particular diameter. I am using the "Size" system parameter in the filter so that I can apply it to both Conduit and Conduit Fittings.

    In the Filter Rules:
    Filter by: Size
    is less than
    1.5

    I placed two conduit runs, one whose Size parameter 1 1/2" diameter for both the Conduit objects and the Conduit Fittings, and another at 1 1/4" diameter.

    The filter seems to either apply or not apply to both runs, regardless of what number I enter in the filter. The filter applies for any value I enter down to 1.1. When I set the number to 1, the filter no longer applies to either run.

    I asked around the office, and everyone agreed that 1 < 1.1 < 1.25 < 1.5

    Am I doing something wrong?

    Thanks in advance.

  2. #2
    100 Club dennis howell's Avatar
    Join Date
    2007-01
    Location
    Suwanee, just north of Atlanta
    Posts
    160
    Login to Give a bone
    0

    Default Re: view filter for conduit size

    This is ugly indeed. The problem is the SIZE value is not treated as a "length" and therefore cannot be used as a value to compare. To get what you are after you will need to work out both positive filters working with negative filters, something like:

    Size contains 2"
    Size does not contain / (example, so that the 3 1/2" isn't grabbed)

    I had a hospital where I wanted to do the same thing. It took a while of tweaking, but I did get it to work for my specific environment.
    No matter how much you adjust your View Range,
    if you have to wear glasses, you will still need to wear glasses.

  3. #3
    Login to Give a bone
    0

    Default Re: view filter for conduit size

    Good tip, thank you.

Similar Threads

  1. Conduit Size Parameter based on the number of wires in the circuit.
    By autocad.wishlist1734 in forum Revit MEP - Wish List
    Replies: 2
    Last Post: 2017-11-01, 04:11 PM
  2. vertical conduit circle size in medium view
    By Ning Zhou in forum Revit MEP - General
    Replies: 6
    Last Post: 2012-07-05, 09:09 PM
  3. Panel Schedules - Wire and Conduit Size
    By heiko.stugg in forum Revit MEP - Families
    Replies: 0
    Last Post: 2011-02-18, 04:24 PM
  4. Conduit Size
    By cparvez in forum AMEP General
    Replies: 2
    Last Post: 2009-12-13, 10:39 PM
  5. MEP CONDUIT SIZE
    By andrzej_makaruk in forum AMEP General
    Replies: 5
    Last Post: 2007-09-13, 06:30 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •