Steel Fabrication

[daniel.tansey187405]

I'm new, so be gentle. I've for the beams/columns/connections modeled and need to start placing everything on sheets to send to the steel fabricator. I'm looking to separate each piece out. How do I do this?

Thanks

[jorgeluisg]

Do you receive any response for this? A few weeks ago I was looking for the same but I cant find nothig.

[themuleman]

I tried to post a link in this reply, but was unsuccessful. If you go to au.autodesk.com>online classes>search classes(narrow by software<autocad structural detailing>) there is a power point presentation you can download that has been very helpful in my learning of ASD2012. Hope this helps

[lucis29]

If you just want to print with "Automatic drawings", there is an option at:

Automatic printouts -> Formats and scales
There you can choose to print Single Profiles under Part Type
Under Arange views -> Mode - choose Single position.

[billbe466349]

Printing details:
How are detail prints made by "non-automatic" method?


billbe (drunk again)

[lucis29]

Printing details:
How are detail prints made by "non-automatic" method?

better

**** - 10 characters

[billbe466349]

lucis29, I believe you!

To rephase; Where is the procedure to use to make "non-automatic" drawings? Is it shown in the ASD manual? If it is not, will you write a outline procedure?

thanks

[jorgeluisg]

Thanks Billy132816, I will.

[lucis29]

lucis29, I believe you!

To rephase; Where is the procedure to use to make "non-automatic" drawings? Is it shown in the ASD manual? If it is not, will you write a outline procedure?

thanks

I've made a small video. If there is something unclear, please tell me.

http://www.screencast.com/t/hAH9hwtFN