Hello, I seen a few previous posts on this but they didn't help with this issue.
I'm using 2012. I have a drawing that came from a contractor and there are 26 layers total. In the layer toolbar pulldown, only the current layer is shown. If an item is selected, then only that layer and the current layer are displayed. If the Layer Property Manager is in autohide, it will show no layers at all. That will say "Unreconciled New Layers: 0 layers displayed of 26 total layers" at the bottom. When I type the LAYER command, all 26 layers will display. Once they all display in the LPM, they will still not show in the layer toolbar.
The older posts suggest PICKFIRST = 1 which is the setting. Any other thoughts or suggestions?
Thanks,
Paul