Results 1 to 2 of 2

Thread: Curtain Panel Pattern Based

  1. #1
    Member
    Join Date
    2012-09
    Location
    Jan Juc Victoria Australia
    Posts
    2
    Login to Give a bone
    0

    Default Curtain Panel Pattern Based

    I think this has been mentioned before - But can someone tell me after making an adaptive curtain panel pattern when applied onto mass the panel hangs over border by 50.8mm (2 inches)? Also panels cut perfectly when set to Partial - justify centre, when set to beginning or end most panels cut fine some overhang see attached.

    Cheers Paul
    Attached Images Attached Images

  2. #2
    AUGI Addict
    Join Date
    2009-03
    Location
    Somerville, MA
    Posts
    1,060
    Login to Give a bone
    0

    Default Re: Curtain Panel Pattern Based

    I submitted this issue to Autodesk support and never got an answer. It was logged on the development list.

Similar Threads

  1. 2012: Curtain Panel Pattern Based.rft Question
    By Jarod in forum Revit - Conceptual Design Tools
    Replies: 6
    Last Post: 2018-02-06, 08:56 AM
  2. Simple pattern based curtain panel
    By rob.127056 in forum Revit Architecture - General
    Replies: 7
    Last Post: 2012-08-29, 09:41 PM
  3. normal vs. pattern based curtain wall panel
    By Ning Zhou in forum Revit Architecture - Families
    Replies: 2
    Last Post: 2010-09-13, 01:41 PM
  4. Replies: 10
    Last Post: 2010-08-25, 12:57 PM
  5. Curtain Panel Pattern Based
    By PaperStreet SoapCO in forum Revit Architecture - Families
    Replies: 0
    Last Post: 2009-06-08, 08:07 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •