Results 1 to 5 of 5

Thread: Failure to launch, well print

  1. #1
    AUGI Addict
    Join Date
    2015-11
    Location
    Madison, WI
    Posts
    1,318
    Login to Give a bone
    0

    Default Failure to launch, well print

    So I am trying to print multiple sheets as a combined pdf. But my pdf printer dies when I print more then 10 elevations sheets at once. I just don't understand. This wasn't a issue in 2012, so what has changed? I'm running on service pack 1.

    Any ideas?

    Jeff S.

  2. #2
    All AUGI, all the time
    Join Date
    2016-02
    Location
    Sydney, Australia
    Posts
    512
    Login to Give a bone
    0

    Default Re: Failure to launch, well print

    I'm guessing. Did you update the PDF driver. Perhaps that would solve it.

  3. #3
    All AUGI, all the time Duncan Lithgow's Avatar
    Join Date
    2006-09
    Location
    Denmark
    Posts
    621
    Login to Give a bone
    0

    Default Re: Failure to launch, well print

    hi jeff. I'd definately look into what's changed with your pdf printer installation as mark suggests.

  4. #4
    AUGI Addict
    Join Date
    2015-11
    Location
    Madison, WI
    Posts
    1,318
    Login to Give a bone
    0

    Default Re: Failure to launch, well print

    I'll submit a help ticket to IT, and we'll see how that goes over... The funny thing is I printed in 2012 three weeks ago. It took over an hour to print, but it went through. Now that I've upgraded it stalls out.
    DWF's seemed to export fast, but the quality was really bad. If I up the quality, I'm sure it will take much longer.

    Cheers,
    Jeff S.

  5. #5
    All AUGI, all the time Duncan Lithgow's Avatar
    Join Date
    2006-09
    Location
    Denmark
    Posts
    621
    Login to Give a bone
    0

    Default Re: Failure to launch, well print

    Poor quality DWF? I don't understand. Are you sure that it was set to 'Remove lines using Vector processing'? Without that you just get a raster picture of your drawing. (Poorly named function. I should be called eg. Export Style Vector / Raster)

Similar Threads

  1. 2011: 3D sketch failure - how to figure out where the failure is??
    By dcook87725927 in forum Inventor - General
    Replies: 1
    Last Post: 2011-05-05, 02:34 PM
  2. RAC won't Launch
    By Mike_Maloney in forum Revit Architecture - General
    Replies: 3
    Last Post: 2008-05-29, 03:30 PM
  3. Spaces in, dashes in or long file names cause print failure.
    By weazel14 in forum AutoCAD Plotting
    Replies: 3
    Last Post: 2006-07-07, 05:53 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •