Dbl leader command *

[cwade]

I might be wrong cause i dont have 2006, but cant you still select object, grab the grip at the point of leader, type "c" (for copy) and then start selecting additional leader head points......

its just a single "C" in replace of holding "shift"

allthough if the "shift" copy is gone in 2006...the should bring it back....

Some say they need to use "ctrl" to copy now, shift works for me though, but this is probably because of the Ortho overide that Shift is now used to control.

[dkh007.66346]

Some say they need to use "ctrl" to copy now, shift works for me though, but this is probably because of the Ortho overide that Shift is now used to control.

In 2006, SHIFT turns on a temporary ORTHO and CRTL will do the copy. CRTL+SHIFT will give you an ORTHO/COPY... Bottom line, this is a great little trick.

Daniel Hargreaves, CSI, RAS
http://www.archsymb.com

[BrenBren]

In 2006, SHIFT turns on a temporary ORTHO and CRTL will do the copy. CRTL+SHIFT will give you an ORTHO/COPY... Bottom line, this is a great little trick.

Daniel Hargreaves, CSI, RAS
http://www.archsymb.com

So great in fact, you should probably post it to the tips and tricks forum

[lcamara]

...cant you still select object, grab the grip at the point of leader, type "c" (for copy) and then start selecting additional leader head points......

I just tried that, but when I right-click after typing the "c" I get a popup menu! (even though I have them turned off)

I am, however, able to use ctrl instead of shift (thanks cwade & dkh007.66346 for info on that).

[Wish List System]

This wish has been reported as granted and already in the software.

[Wish List System]

The wish has already been granted. This thread is closed to further posts.