Results 1 to 8 of 8

Thread: Panel Schedule not populating sub panel loads

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Member
    Join Date
    2009-06
    Location
    Salt Lake City, UT
    Posts
    4
    Login to Give a bone
    0

    Default Panel Schedule not populating sub panel loads

    I am having a problem getting the load information to populate in the circuit section of the panel schedule. The information comes through in the total connected load information at the bottom of the schedule, but not in the circuit information.

    I've checked everything that I can think of. When I circuit the panels together, this load should come through... right?

    Any insight would be helpful.

    See the attached schedule

    Thank you,
    Attached Images Attached Images

Similar Threads

  1. 2014: Electrical Panel Schedule (1-Phase Panel to a 3-Phase Panel)
    By Binu Mathew in forum Revit MEP - General
    Replies: 3
    Last Post: 2015-03-26, 02:56 PM
  2. Panel Schedules - Existing Loads
    By Wish List System in forum Revit MEP - Wish List
    Replies: 1
    Last Post: 2014-11-13, 06:24 PM
  3. Prevent an electrical panel with loads from being deleted
    By Wish List System in forum Revit MEP - Wish List
    Replies: 0
    Last Post: 2012-06-13, 08:21 PM
  4. Adding linear loads to panel edges in Revit
    By strozy in forum Robot Structural Analysis
    Replies: 5
    Last Post: 2010-07-07, 05:13 PM
  5. Applying loads to panel edges in Revit
    By strozy in forum AutoCAD Structural Detailing
    Replies: 0
    Last Post: 2010-06-29, 09:05 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •