Always used LDD and C3D...Now on AutoCAD2012. How do I do a bearing and distance line table?

[nate.evans79366070]

I'm lost, I don't have any of my Civil add-ons or survey stuff. I am now working at a very small company...me and the engineer. We do Civil Site Design. But we only have AutoCAD 2012. I have used LDD and C3D for years before this. Long story short, we are doing a favor for a surveyor, and I am working on a wetlands map that has 1000 or more deliniation lines that need labled and I need to create a bearing and distance line table for them. Normally, this would be a few clicks and about 5-10 mins of cleanup work. But I can't figure out if its even possible now with the basic program. Any ideas, or lisp routines that would work for this platform? Thanks everyone!

[Opie]

There are probably some AutoLISP routines out there to help. Otherwise, it will not be a quick and easy task.

You might be able to create a dynamic block to display the bearing and distance between two points.

[rkmcswain]

>>But we only have AutoCAD 2012.
>>I need to create a bearing and distance line table for them.
>>Any ideas, or lisp routines that would work for this platform?

Take a look at http://dotsoft.com/mapworks.htm and/or http://www.carlsonsw.com
If this is a one time deal, get a Carlson demo and use it (it is good for so many commands, plenty enough to run a line table)