plumbing section.JPG
I've drawn domestic cold water pipe that's visible in section, but not in plan view. I've reviewed the following visibility settings without success:
There is a plumbing workset, which is active & visible, and the pipes are drawn on the active workset.
Changing detail level and visual style has no affect. Pipe is still not visible in plan.
See attached image for levels in project. View range settings are: Top: 3rd Level, cut plane: 4 ft offset of associated level, Bottom: Second Level
The Domestic Cold water pipe is at the same elevation (10 feet above Bottom Level) in section as Domestic Hot Water pipe which is visible in plan view.
There is a Domestic Cold Water visibility filter, which is checked on. Domestic cold water pipe is filtered by System Classification
The Pipe model category is turned on in Visibility Graphics
The plan View Discipline is set to Mechanical
The Sub-Discipline is set to Plumbing
The project has an Existing and New Phase
The pipe is on the Existing phase
The Phase Filter is set to Show Previous and New
The active Phase is New Construction
Changing the active Phase to Existing has no affect. Pipe is still not visible in plan.
There is a View Template for Plumbing Plan views. The View Template's Visibility Settings are the same as those described above.
Any suggestions would be much appreciated.