I have linked multiple files in to a master set. An issue I have is with the Underlay function in the master set.
In my linked file to the left (See attached) I have the floor plan turned on in my Underlay and the Underlay Orientation set to Reflected Ceiling Plan to reflect my soffits and dropped ceilings (The grey dashed line). It works fine and looks good when printing.

However when I bring up the same view in my master set (the view to the right), the view is set to By Linked View and the correct view is picked, but no Underlay is present even if I turn it on in the Properties bar.

Can someone please tell what I might be doing wrong or if Revit doesn't allow this particular function to occur.

Thank you,
Screen Capture.JPG