Editing parcels

[tim_newsome]

I have 2 parcels that share a radius. I want to remove the radius completely so that the shared lot lines meet at PI.

I am hoping to make this change without losing lot #s.

[Opie]

I am not certain I completely understand what you are wanting to do.

Did you know you can renumber the parcels? You can find this option in the Ribbon and the menu bar for Parcels.

[tim_newsome]

Sorry Opie, I try to make the point efficiently in consideration and sometimes I find that efficiency lacks a clear point.

I want to delete the curve (ignore Cyan line in image) that lot 22 & 29 share and extend both tangents to a PI. I went to "Parcel Layout Tools" and used the "Delete Sub-Entity" command for the curve. That's where I was unsure of what to do next to reconstruct lot 22 & 29. I used the "Add fixed lines - two points" and renumbered the lots. That achieved my objective but it feels like I could have used the "Edit Parcel Commands" to modify rather than redraw.

What would you have done?

[Opie]

What would you have done?

I don't know. I seldom use Parcels in my daily drafting as they are not part of my focus at my firm.

What you have done worked. But I agree, you should be able to use the Edit Parcel Commands to do what you needed to do without removing and replacing the curve.