Power/Data circuiting & Lighting circuiting

[jigarpatel.civil282969]

Hi All,

I am facing 2 problems with light and power circuting

1) when I circuit 3 -phase receptacle to circuit board it only allocated one circuit number not 3. For an example if I do circuiting then it only allocated Circuit no 1 but I want Circuit no 1,2,3 so for next respectable it should allocate 4,5,6..is that possible?

2)I want to do circuiting for lighitng & power on same DB board so I am looking for when I do power circuiting its start from 1,2,3,4,5..... and when I do lighting it start from 1,2,3,4... I mean separate allocation for power & lighting....

Can some one please help me?

If possible then please upload revit sample file....

Thanks in advance..

[mhartmann]

1. if you set your receptacle for 208 Volts and 3 Poles, it should land on circuits 1,3,5. verify it's not set to 120 Volts and 1 Pole. also make sure you have the correct voltages defined and set up in your project electrical settings.

2. it's not going to let you call two different circuits the same circuit numbers, if that's what you're trying to do. you would have to create a separate power board and lighting board to have them both start at circuit number 1. maybe I don't understand what you're asking, that doesn't seem logical to have different loads shown as the same circuit number...

hth,
mike