Revit 2014
I am having a frustrating time adding side tapped grille to a mian trunk line.
This is how I finally accomplised it, but is there an easier way?!
1. I drew a duct (16x6) 15" of the main line. That is long enough for a beveled tap to generate.
2. I then place on vertical face the 16x6 side register to the end of the duct.
3. I then delete the duct I originally drew (the bevel remains).
4. I select the grille and click on the icon that allows me to draw duct from the register. I do so, and run it to the bevel.
5. Since the new duct does not exactly line up with the bevel, I window the new duct and the grille and move it until it lines up with the bevel.
6. At this point I add a balalncing damper in the middle of the short duct run.
PLEASE TELL ME THERE IS AN EASIER METHOD!