Hello fellow users.This is my first post here on AUGI.I have this problem with RSAP 2014:I want to transfer the slab load to my primary beams through secondary ones.I used the command Divide in order to create the necessary nodes at my primary beams and it worked in terms of not getting any error messages during the calculations.But when i checked the results i realized that no loads or forces had been transferred to my primary beams.As you may see in this screenshot the main beam seems to be without any M or Fz.I'm trying to look an answer but haven't figure out anything yet.Finally using cladding also doesn't help as the only thing that is done in that case is good load distribution
M_Q diagrams.png