I have been trying to array a symbolic (glass projection) line in a window family to represent some glass louvre blades in elevation.
Before arraying the line I can constrain the length of the line by either locking it to the left and right reference planes of the window opening or by adding a parameter to make it equal to the "Width" of the opening.
Both methods work fine with just the one line.
Once I array the line vertically to fill the window void it starts to play up.
I array the line by using the "group and associate" and "move to 2nd" options. I then add a parameter to control the distance between the two lines eg. 150mm
Next I add a parameter between the two lines to calculate the total amount of line in the void.
This parameter formula is "(Height / 150 mm) - 1".
The vertical array is fine and works ok. But when I adjust the width of the opening I start getting "constraint errors" relating to the width.
Any suggestions on where I am going wrong?