Problem with Pads and linked RVT

[rgranja508683]

I have a site plan with a surface and some buildings that are linked, than I create a pad in each building. Now my problem is in the building that are linked, I open one of the buildings and link the site plan. When I create a section that pass over the pad and the wall foundation i see the lines of the pad that pass over the foundation wall.
How can I do that without have this kind of problems?

Regards,
Ricardo

[Steve_Stafford]

To properly interact with the site topo you'll need to put the pads in the site project.

[rgranja508683]

I put the pads in site project. My problem is in interact with the wall foundation.

[Steve_Stafford]

...I put the pads in site project...

Sorry, didn't realize that. Where are you cutting the section? Site or bldg project file? In either case, using visibility/graphics to turn of the site category should remove it. In the site project you could use the line work tool. You can also make the pad very thin so it just looks like a joint?