Originally Posted by
marstevons674491
I just did the following with the USCDETECT toggled to both OFF and ON and neither setting has any effect.
1. In Top view, set UCS to World.
2. Set Base at 0,0,0.
3. Drew a Sphere at 0,0,0.
4. Switched view to Front and used the ID command to list the XYZ coordinates of the Sphere.
5. Sphere location is still listed at 0,0,0.
6. Switched view to Left and used the ID command to list the XYZ coordinates of the Sphere.
7. Sphere location now lists as being at X = 1540.97772320 Y = -252.46221430 Z = -233.19280050
8. Switched view back to Top and used the ID command to list the XYZ coordinates of the Sphere.
9. Sphere location now lists as being at X = 1540.97772320 Y = -252.46221430 Z = -233.19280050
If I want the Spere to shw as being at 0,0,0 again I need to go back and reset the UCS to World.