Results 1 to 2 of 2

Thread: error starting AutoCADLT 2005

  1. #1
    Active Member iffans's Avatar
    Join Date
    2004-10
    Location
    Jakarta, Indonesia
    Posts
    53
    Login to Give a bone
    0

    Question error starting AutoCADLT 2005

    Hi. I'm having a problem with AutoCAD LT 2005. I used to use LT 2004 and now I wanna upgrade to LT 2005. But after I installed it and ran the program, it was stopped at 47% and not responding. It happened all the time and it was never been opened.
    Then I tried to open it in safe mode. Still couldn't be opened and message error about license system error appeared (look at the attachment file). Finally I uninstalled both LT 2004 and 2005 and reinstalled LT 2005. No problem during the installation. But when I started the program there was message error then it happened again. Not responding and I had to shut down the program. What's wrong with the program? My computer specification : Intel Pentium IV 2,8 GHz ; HDD 40 GB ; 512 MB RAM ; OS Windows XP Prof SP1. Thanks.
    Attached Images Attached Images

  2. #2
    The Silent Type Mike.Perry's Avatar
    Join Date
    2000-11
    Posts
    13,657
    Login to Give a bone
    0

    Default Re: error starting AutoCADLT 2005

    Hi

    Check out the following Technical Documents on the Autodesk web site under the Knowledge Base section -

    ID: TS100492 - AutoCAD LT® closes with a fatal error even when sitting idle

    ID: TS100378 - Error while attempting to run AutoCAD® 2005-based programs in Windows Diagnostic mode

    Have a good one, Mike

Similar Threads

  1. When starting VBAIDE Fatal error
    By nickatndprecast in forum VBA/COM Interop
    Replies: 1
    Last Post: 2010-06-17, 05:23 PM
  2. Error message when starting Acad 2008
    By drafting.82475 in forum AutoCAD Customization
    Replies: 7
    Last Post: 2008-03-27, 09:09 AM
  3. Fatal Error while starting AutoCAD 2000
    By satish in forum AutoCAD General
    Replies: 3
    Last Post: 2006-08-22, 11:31 AM
  4. Runtime Error when starting
    By jonathan.landeros in forum Inventor - General
    Replies: 1
    Last Post: 2006-02-17, 06:33 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •