Results 1 to 2 of 2

Thread: pipe weight in the spec

  1. #1
    Login to Give a bone
    0

    Default pipe weight in the spec

    Hi all,

    I am just starting with Plant3D after many years in other software and was just looking at writing a pipe spec and noticed that default settings for pipe weight is lb/ft. I cannot find a switch or toggle that allows me to have this weight in metric. (I still want to keep the pipe bore as imperial. Similar to that of Cadworx metric specifications)

    Any assistance would be great.

    Also does anyone have some good learning reference material online or a link to a good book on both P&ID and plant?

    Thanks,
    Scott

  2. #2
    Member
    Join Date
    2017-03
    Posts
    6
    Login to Give a bone
    0

    Default Re: pipe weight in the spec

    Hi Scott, there are a few solutions you could explore:

    1.Visit the Autodesk App store, I think there is a Metric ASME catalog available for purchase, although:

    2.It sounds like all you want are metric lengths and weights but imperial pipe diameter callouts correct?
    In that case I would simply build your specs using the included ASME catalog even though it's all imperial
    and when it comes to setting up a project just select "Metric" unit settings and then select "Inches (Mixed Metric)" for the reporting of nominal diameters.
    Plant 3D will handle the conversion of units for you. See the pic below.

    As far as manual go, check these out:

    Tailoring AutoCAD P&ID and AutoCAD Plant 3D
    Plant 3D Isometrics
    Report Designer Manual

    There are also a bunch of videos on youtube from Autodesk and others, just do a search and you'll find a ton of stuff.

    new project.png

Similar Threads

  1. 2011: Pipe-in-pipe, containment pipe, double-wall pipe ?
    By Super T in forum Revit MEP - General
    Replies: 4
    Last Post: 2019-08-15, 12:51 PM
  2. Replies: 3
    Last Post: 2015-12-05, 08:19 PM
  3. PC Spec
    By anthony.hoare in forum Revit Structure - General
    Replies: 3
    Last Post: 2007-07-17, 11:37 PM
  4. line weight #1 at 1/8" scale line weight too thick and not .003"
    By 3dsketcher in forum Revit Architecture - General
    Replies: 2
    Last Post: 2006-11-14, 10:13 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •