I am working on a job where they are requiring me to do spools. I have created a set of spool drawings and plotted them. I went home for the weekend and came back this morning and needed to do some minor changes. The changes were very minor and didn't change anything in the spool itself. When I opened the drawing this morning, all of my number tags are missing. I tried regenerating with RegenAll, after that, I'm at a loss. I haven't a clue as to what would cause this, and why it showed up fine the last time I worked on them. I did a total of 16 spools and it has done it on all of them. I really don't want to have to do all of these over again. Any and all suggestions would be much appreciated.