Results 1 to 5 of 5

Thread: Isolate One Object

  1. #1
    Active Member Jarod's Avatar
    Join Date
    2004-03
    Posts
    81
    Login to Give a bone
    0

    Default Isolate One Object

    I want to isolate the brick floor under the deck so it does not plot. The hot tub and lower concrete floor is on the same lower level but I do want them to print. If I turn off floor in the view properties than I lose all of the floors. How do I just get the brick floor not to show?
    Attached Images Attached Images

  2. #2
    AUGI Addict Joef's Avatar
    Join Date
    2003-12
    Location
    Victoria, BC
    Posts
    1,273
    Login to Give a bone
    0

    Default Re: Isolate One Object

    It looks like you are using the lower level as an underlay. You can't isolate the floor, but you could use the linework tool and trace the objects that you want to appear, then turn off the underlay. Somebody is bound to tell you to use worksets, but I wouldn't.

  3. #3
    Active Member Jarod's Avatar
    Join Date
    2004-03
    Posts
    81
    Login to Give a bone
    0

    Default Re: Isolate One Object

    Thanks for the help, it is kind of lame that you can't isolate something for plotting when it is a underlay. I don't see how doing Worksets would help with this situation.

    At least I can stop now...Thanks Again...

  4. #4
    Revit Mararishi aaronrumple's Avatar
    Join Date
    2002-02
    Location
    St. Louis, MO
    Posts
    4,695
    Login to Give a bone
    0

    Default Re: Isolate One Object

    Don't use an undelay. What you need to do is set your view range correctly. Set the distance below to level below (or unlimited.) The deck will hide the brick then.

  5. #5
    Active Member Jarod's Avatar
    Join Date
    2004-03
    Posts
    81
    Login to Give a bone
    0

    Default Re: Isolate One Object

    Holy Carp! I swear I tried this before I posted but guess what, it's working now...Thanks Again for everyones help.

Similar Threads

  1. Isolate/select line with object on both ends
    By opesch in forum AutoLISP
    Replies: 2
    Last Post: 2013-11-25, 09:10 AM
  2. Command to Isolate Object(s)
    By autocad.wishlist1734 in forum AutoCAD Wish List
    Replies: 3
    Last Post: 2013-01-15, 04:37 AM
  3. Isolate selection only
    By Serhan_BAKIR in forum Robot Structural Analysis
    Replies: 2
    Last Post: 2011-12-13, 02:45 PM
  4. 8.1/E - Add "Make Object Wireframe" to the Temp Hide Isolate - O
    By Scott D Davis in forum Revit Architecture - Wish List
    Replies: 0
    Last Post: 2005-12-22, 02:17 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •