Results 1 to 4 of 4

Thread: Electrical Panel Schedule (1-Phase Panel to a 3-Phase Panel)

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    100 Club Binu Mathew's Avatar
    Join Date
    2005-11
    Location
    Kuwait
    Posts
    187
    Login to Give a bone
    0

    Default Electrical Panel Schedule (1-Phase Panel to a 3-Phase Panel)

    We are using Revit 2014 and noticed the following issue :-

    When we connect devices into a Single phase panel the circuits are falling in panel schedules display correctly. However, when we connect the Single Phase panel to a 3-phase panel the load gets distributed in 3-phases at the bottom totals (the load display in 3-phase panel schedules eg:- if there is 5 circuits the 1st and the 4th circuit load adds it mean only R-phase) any idea what happening ?. iam attaching herewith the images of the SPN and TPN panel schedules and SPN panel properties
    Attached Images Attached Images
    Last edited by Binu Mathew; 2015-03-26 at 08:00 AM.

Similar Threads

  1. 2013: Panel Schedule not populating sub panel loads
    By jkrstich in forum Revit MEP - General
    Replies: 7
    Last Post: 2015-12-07, 09:08 PM
  2. 2012: Electrical Circuiting - 3 Phase - Output to Panel Schedule
    By gra77 in forum Revit MEP - General
    Replies: 2
    Last Post: 2013-08-01, 08:47 AM
  3. 2012: Amps per phase for panel different than feeder circuit
    By nmulder in forum Revit MEP - General
    Replies: 3
    Last Post: 2013-07-16, 04:03 PM
  4. 2012: Panel Schedules adjusted per phase current demand
    By joshore in forum Revit MEP - General
    Replies: 0
    Last Post: 2012-02-28, 04:00 PM
  5. Electrical Panel Schedule
    By neb1998 in forum Revit Architecture - General
    Replies: 3
    Last Post: 2005-05-31, 11:13 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •