Hello,
It seems as if Revit 2015 r7 is discriminating against which families bring "Element" Properties into Navisworks 2015 sp3. Perhaps by category?
For instance:
- Cable Tray Fittings YES
- Light Fixtures NO
- Pipe Accessories YES
- Duct Accessories NO
- Equipment NO
- Floors YES
- Doors NO
- Walls YES
- Windows NO
- Ceilings YES
- Specialty Equipment NO
Ideally I should be able to see such parameters as Description, Comments, Type Mark, Dimensions, etc.
Export settings attached, any insight would be greatly appreciated.
Thanks!