|
|
corridor extents as outer boundary - shrinkwrap boundary
Hello,
I was wondering if anyone has came across an issue where when you use the corridor extents as outer boudary in the corridor that it will cut off you surface in a curb return region. Surface displays fine until adding the boundary. I add the boundary so i can paste the corridor surface into my fg surface and build out the rest of my site using the fg surface. Any tips or ideas what I am doing wrong would be greatly appreciated.
Thank you
Re: corridor extents as outer boundary - shrinkwrap boundary
Is there a gap between your curb return and the remaining corridor? I have found a gap between regions can cause this behavior.
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt
Re: corridor extents as outer boundary - shrinkwrap boundary
you might also check the length of your tin lines since they are always straight I have had a curved line cut off one edge that removes the whole face there. there is a setting to adjust the triangulation intervals you may need to set it smaller
Posting Permissions
Reply With Quote