Results 1 to 3 of 3

Thread: corridor extents as outer boundary - shrinkwrap boundary

  1. #1
    Member
    Join Date
    2015-05
    Posts
    6
    Login to Give a bone
    0

    Default corridor extents as outer boundary - shrinkwrap boundary

    Hello,
    I was wondering if anyone has came across an issue where when you use the corridor extents as outer boudary in the corridor that it will cut off you surface in a curb return region. Surface displays fine until adding the boundary. I add the boundary so i can paste the corridor surface into my fg surface and build out the rest of my site using the fg surface. Any tips or ideas what I am doing wrong would be greatly appreciated.

    Thank you
    Attached Images Attached Images

  2. #2
    Administrator Opie's Avatar
    Join Date
    2002-01
    Location
    jUSt Here (a lot)
    Posts
    9,138
    Login to Give a bone
    0

    Default Re: corridor extents as outer boundary - shrinkwrap boundary

    Is there a gap between your curb return and the remaining corridor? I have found a gap between regions can cause this behavior.
    If you have a technical question, please find the appropriate forum and ask it there.
    You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
    jUSt

  3. #3
    I could stop if I wanted to
    Join Date
    2014-08
    Posts
    450
    Login to Give a bone
    0

    Default Re: corridor extents as outer boundary - shrinkwrap boundary

    you might also check the length of your tin lines since they are always straight I have had a curved line cut off one edge that removes the whole face there. there is a setting to adjust the triangulation intervals you may need to set it smaller

Similar Threads

  1. how to extract corridor boundary ?
    By robert.248186 in forum AutoCAD Civil 3D - Corridors
    Replies: 2
    Last Post: 2013-08-29, 02:38 PM
  2. Replies: 0
    Last Post: 2012-03-29, 05:35 AM
  3. Corridor and Boundary
    By mannu21 in forum AutoCAD Civil 3D - Corridors
    Replies: 3
    Last Post: 2009-11-27, 02:21 AM
  4. Corridor Boundary
    By allyn1980 in forum AutoCAD Civil 3D - General
    Replies: 4
    Last Post: 2008-04-30, 01:12 AM
  5. Corridor boundary
    By kwdsku in forum AutoCAD Civil 3D - General
    Replies: 4
    Last Post: 2005-08-09, 02:59 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •