Somebody can explian the logics behind revit input and survey input of bearing distance?
thanks
|
|
|
Somebody can explian the logics behind revit input and survey input of bearing distance?
thanks
Try it again and follow the bearings and dimensions around a the circle. Your first line and second line back on one another and the last two are going the same direction the way you typed them in the table. Perhaps you didn't notice the direction of the second N S E W after the angle.
I did try several times but no matter where I start or the direction of the circle I choose I can't do Revit to draw or tag the same direction as the survey. I make the property lines to close and draw correctly but the tags will read different from the survey.
I am really confuse. Thanks for your help anyway.
Last edited by Wagurto; 2005-03-22 at 05:15 PM.
Hold on. don't give up I'll do it and post the table back in a minute
I started in the upper left and went around
Thanks Chirs for the time you are taking to help me!
I am Attaching a image with some comments and that is what I don't understand.