Hi everyone,
I am creating some MEP Revit families and I have a question :
How do you place a connector wherever you want on a face? (I don't want it in the middle of the face...)
Thanks for your help!
JI
|
Hi everyone,
I am creating some MEP Revit families and I have a question :
How do you place a connector wherever you want on a face? (I don't want it in the middle of the face...)
Thanks for your help!
JI
Ugangi,
Place the connector on a workplane instead of a face to allow it to be relocated.
You should then be able to constrain the position of the connector using dimensions. You may need to convert the temporary dimensions, that appear when the connector is selected, to permanent dimensions to allow for this.
Hope this helps,
Last edited by Eddy B; 2016-05-02 at 02:46 PM.