Summary: Being able to swap pressure pipe without deleting and re-drawing them.

Description: We are using ad in software ProNET, from Prokon which enables AutoCAD to do EPANET water distribution network calculations, however due to network modeling the pipe sizes change in the EPANET environment. We currently have to delete the incorrect pipe and redraw each pipe in a network of approximately +500 pipes and nodes. this is tedious and time consuming, any assistance with enhancing the pressure network module would improve AutoCAD.

Product and Feature: AutoCAD Civil 3D - Pipe Network

Submitted By: keesje.verhage730424 on 06/22/2016