Scale - Dynamic Block

[John King]

Greetings To All,

I am a new user to this website, which was recommended to me by another forum that I utilize.
I am looking for a dynamic scale block which has the following scales: 1/16", 1/8", 1/4", 3/8", 1/2", 3/4", 1", 1 1/2" and 3" to the foot. I would like to have one insertable block that I can change based on the scale of the drawing.
Is there anyone out there that has seen this before or does a block of this capability exist? Any help would be great.

[Ryan.Go]

Yep! It is possible for sure.
You need to set a parameter (BPARAMETER)
Then add a Scale Action (BACTION)

Here is some more info from the Autodesk Knowledge network:

[tedg]

Greetings To All,

I am a new user to this website, which was recommended to me by another forum that I utilize.
I am looking for a dynamic scale block which has the following scales: 1/16", 1/8", 1/4", 3/8", 1/2", 3/4", 1", 1 1/2" and 3" to the foot. I would like to have one insertable block that I can change based on the scale of the drawing.
Is there anyone out there that has seen this before or does a block of this capability exist? Any help would be great.

There USED to be a Dynamic Block Sharing Thread.. which is closed now (at least to me, not sure if it's active for those paying for membership?)
Anywho.., I had posted a dyn block many years ago with what you are looking for, see attached.

HTH

[kslifter]

thanks for sharing! That is an awesome dyn. block!

[zkrueger771724]

This dyn block came in handy to me, just now. Thx, Tedg.