Hi there!
I am using subassembly composer to create roadline with sholder and curb if slope is "-".
The problem is with this base point.. I am putting my "daylight" subassembly in the end of the sholder but when i am having "curb" (it is there when the lane slope is under 0%) daylight subassembly moves away from the attachment point. Here is an example:
Attachment 104293this is where my attachment point is
Attachment 104294
And here where it is moved when i actualy build cross sections...

The other thing that i've noticed is that if my slope is over 0% (and i have no curb) the attachment point is where it should be:
Attachment 104295
Here is what i see in the composer
Attachment 104296
All the points are having exactly the same point codes the only difference is that curb..

I will apriciate any help! Thanks in advance!