Auto Numbering - HELP!!

[Robb_FE]

Good afternoon, all.

I'm currently looking for a solution to an issue. My planning drafters used to use AutoCAD, but recently switched to AutoCAD LT 2017. Unfortunately, there is no 3rd party apps, so the auto-numbering lisp they used to use, no longer works.

Has anyone found a way to replicate an auto-numbering app within the LT program? I know it's more of a convenience than anything else, but if anyone has any ideas or insight, I would greatly appreciate it.

Thanks.

Robb
FE Design Lead Drafter

[rkmcswain]

There is a solution for that here:

http://forums.augi.com/showthread.ph...for-AutoCAD-LT

[bandungpunk751143]

Good afternoon, all.

I'm currently looking for a solution to an issue. My planning drafters used to use AutoCAD, but recently switched to AutoCAD LT 2017. Unfortunately, there is no 3rd party apps, so the auto-numbering lisp they used to use, no longer works.

Has anyone found a way to replicate an auto-numbering app within the LT program? I know it's more of a convenience than anything else, but if anyone has any ideas or insight, I would greatly appreciate it.

Thanks.

Robb
FE Design Lead Drafter

same case, i need auto-numbering lisp for Autocad LT, i hope everyone can help us .

[tedg]

same case, i need auto-numbering lisp for Autocad LT, i hope everyone can help us .

Well did you check out rkmcswain's link?
LT dosn't "do lisp" so your best bet is a macro:

There is a solution for that here:

http://forums.augi.com/showthread.ph...for-AutoCAD-LT

[connor750748]

Doesn't work since 2016 if I'm not mistaken