Results 1 to 2 of 2

Thread: CADMEP Services

  1. #1
    Woo! Hoo! my 1st post
    Join Date
    Login to Give a bone

    Default CADMEP Services

    I am just learning the software and obviously the services seem to be the heart of the program. I can find no documentation as to how to set them up properly. Where can I find the proper way to set them up. Say I want to setup hangers, insulation, some design lines do not fill from a imported revit design line. I find one setup works and then another wont. Some imported lines have hangers others dont. Some elbows fill in and yet others do not. So any help is greatly appreciated.

  2. #2
    Woo! Hoo! my 1st post
    Join Date
    Login to Give a bone

    Default Re: CADMEP Services

    There are alot of options for this. First who is your software provider for the Fabrication products. Our provider provides most of this information in a Value pack where alot is already setup for you. Please email me and we can discuss more. Thanks

Similar Threads

  1. 2016: Fabrication CADMep 2016 - 3D look on duct/pipes
    By joseph.rice694922 in forum CADmep General
    Replies: 0
    Last Post: 2016-12-05, 03:01 PM
  2. 2011 Cut Lengths for FP piping in CADmep 2011
    By kleenhippie in forum CADmep General
    Replies: 1
    Last Post: 2015-11-11, 03:55 PM
  3. 2013 CADmep 2013 SP5 is out
    By DarrenYoung in forum CADmep General
    Replies: 0
    Last Post: 2014-03-11, 06:02 PM
  4. CadMep block conversion
    By hicham3617440183 in forum AMEP General
    Replies: 8
    Last Post: 2012-09-15, 11:54 AM
  5. CADmep+ Pipe Slope in Navis?
    By j_menacker in forum NavisWorks - General
    Replies: 2
    Last Post: 2012-02-27, 06:59 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts