I cant find it, and with all the tools that are available, I cant believe that this one doesnt exist. I think almost all the tools that are available in the elevation editor table, are also available to edit points outside of the table, graphically on screen, except the one I need.
I'm looking to adjust a pi's elevation by a relative amount. I'm running curb feature lines, and I've got my back of curb, where I need to dub it down for sidewalk ramp access. I cannot find a fast way to just say, drop this point or these 5 points 0.42 feet. The elevation editor can do it, but I spend way too much time guessing what my start and end stations are. I dont want to lower the entire feature line, just small portions of it.
Any suggestions would be appreciated,
Thanks,