Results 1 to 2 of 2

Thread: Create a warning if grading is too steep

  1. #1
    Active Member justin.d.ehart's Avatar
    Join Date
    2004-11
    Location
    Denver, Colorado
    Posts
    54
    Login to Give a bone
    0

    Default Create a warning if grading is too steep

    So, we had it brought up that it would be helpful if we had a label or an area in a surface/corridor if thengrading exceeded a certain percentage.

    I think it's a great idea, but not sure which direction to go. Would an expression for a label with an "IF" statement would work, or if anyone else has done this, some ideas would be much appreciated!

    Thanks in advance!!

    - JDE

  2. #2
    I could stop if I wanted to
    Join Date
    2015-10
    Location
    Central New Jersey
    Posts
    391
    Login to Give a bone
    0

    Default Re: Create a warning if grading is too steep

    In the surface properties you could set a slope surface analysis with one range for slopes greater than a set slope and it will hatch those surface triangles that fit within that range. Just edit the initial range that it creates from the surface to set a minimum slope to start the range.

Similar Threads

  1. 2017: Create grading from one feature line to another
    By tadthurston725387 in forum AutoCAD Civil 3D - General
    Replies: 1
    Last Post: 2017-04-21, 12:23 AM
  2. Question on Lisp, trying to create a Warning Box.
    By Dr._House in forum AutoLISP
    Replies: 30
    Last Post: 2009-09-17, 08:25 PM
  3. Warning - Can't Create?
    By cadman6735 in forum Revit Architecture - General
    Replies: 0
    Last Post: 2008-10-21, 09:42 PM
  4. Warning: Could not create geometry for Space.
    By nosten in forum Revit MEP - General
    Replies: 2
    Last Post: 2008-09-30, 09:12 PM
  5. Steep Slopes - Grading Analysis
    By luke.repsher in forum Land Desktop - General
    Replies: 5
    Last Post: 2005-08-02, 09:40 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •