See the top rated post in this thread. Click here

Results 1 to 5 of 5

Thread: Why is this happening

  1. #1
    Member
    Join Date
    2018-09
    Posts
    7
    Login to Give a bone
    0

    Default Why is this happening

    Hello to everyone,

    I am having some doubts about this.. why is the blue dot on front of the lement, and yet it didn´t stretched. the picture was uploaded above.

    best regards
    Attached Images Attached Images

  2. #2
    Administrator Ed Jobe's Avatar
    Join Date
    2000-11
    Location
    Turlock, CA
    Posts
    5,637
    Login to Give a bone
    0

    Default Re: Why is this happening

    This is probably not the right forum. What software are you using? I can move it to the correct forum.
    C:> ED WORKING....

  3. #3
    BIM/VDC Management Brian Myers's Avatar
    Join Date
    2003-02
    Location
    St Louis, Missouri
    Posts
    1,815
    Login to Give a bone
    1

    Default Re: Why is this happening

    Ed, the software is Revit. Usually when you see this there is a wall cleanup involved that is causing the walls to "resolve" into a more cleaned up corner condition. It's a bit unclear what was being attempted, but my initial thought would be to use "disallow join" by right clicking on the blue dot to achieve the potential desired result.
    Brian Myers
    Jacobs: VDC Design Office Lead (BIM Leadership)
    Visit my LinkedIn Profile for more information.

  4. #4
    Member
    Join Date
    2015-09
    Posts
    47
    Login to Give a bone
    0

    Default Re: Why is this happening

    I'd bet my paycheck that's a wall with an edited sketch. There's almost zero reason to ever edit the wall sketch.

    Haha .. I just noticed this post is six months old. Oh well...

  5. #5
    Woo! Hoo! my 1st post
    Join Date
    2019-11
    Posts
    1
    Login to Give a bone
    0

    Default Re: Why is this happening

    Really, I have been going through the same?

Similar Threads

  1. DT131-4U: Integrated Project Delivery: Is It Happening? How Is It Happening?
    By Autodesk University in forum Design Technology
    Replies: 0
    Last Post: 2015-08-07, 05:27 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •