Hello to everyone,
I am having some doubts about this.. why is the blue dot on front of the lement, and yet it didn´t stretched. the picture was uploaded above.
best regards
|
|
|
Hello to everyone,
I am having some doubts about this.. why is the blue dot on front of the lement, and yet it didn´t stretched. the picture was uploaded above.
best regards
This is probably not the right forum. What software are you using? I can move it to the correct forum.
C:> ED WORKING.... ▒
Ed, the software is Revit. Usually when you see this there is a wall cleanup involved that is causing the walls to "resolve" into a more cleaned up corner condition. It's a bit unclear what was being attempted, but my initial thought would be to use "disallow join" by right clicking on the blue dot to achieve the potential desired result.
I'd bet my paycheck that's a wall with an edited sketch. There's almost zero reason to ever edit the wall sketch.
Haha .. I just noticed this post is six months old. Oh well...