Hi everyone!
It's my first post here so be kind with me!
I'm good with dynamic block (general base!) but I have a problem with one that I'm trying to do. I have a dynamic block for architectural glass wall with a door.
I managed to have one visibility state that shows the door, a glass wall and a little section of glass wall in 45°. The door, the glass wall, the section in 45° and the wall thickness can stretch. I would like to be able to flip all the block and only the small section of glass wall in 45°. So this is where it gets confusing. I did the flip for all the block but my problem is when I flip only the small section. If I do so, when I stretch the wall thickness, it doesn't follow because it is like backwards. I have attached the block. Sorry in advance, the visibility states are in French!
Can a kind expert in dynamic block can help me please?!
Thank you
Stephanie