Results 1 to 3 of 3

Thread: How to align a line in edit profile mode to a sloped plane?

  1. 2019-04-15, 06:34 AM #1
    awaisrauf95728294
    awaisrauf95728294 is offline
    Woo! Hoo! my 1st post
    Join Date
    2016-05
    Posts
    1
    Login to Give a bone
    0

    Default How to align a line in edit profile mode to a sloped plane?

    Hi experts,

    I'm working on a project where the entrance roof is sloped at 2 degrees. The curtain wall at the entrance needs to attach perfectly to the base of the roof. Using Attach Top/Base command doesn't do anything. And I even tried to align the profile line of the curtain wall (magenta) to the face below but nothing happens. Any help would be appreciated.

    Regards,
    Awais
    Attached Images Attached Images
    Reply With Quote Reply With Quote
  2. 2019-04-15, 05:15 PM #2
    PijPiwo
    PijPiwo is offline
    I could stop if I wanted to
    Join Date
    2010-10
    Location
    Chicago, IL
    Posts
    376
    Login to Give a bone
    0

    Default Re: How to align a line in edit profile mode to a sloped plane?

    Attach Top/Base should work. Are you sure you're selecting a curtain wall itself, not a panel or a mullion?
    Reply With Quote Reply With Quote
  3. 2019-04-15, 09:01 PM #3
    Bill Gilliss
    Bill Gilliss is offline
    100 Club
    Join Date
    2015-12
    Posts
    102
    Login to Give a bone
    0

    Default Re: How to align a line in edit profile mode to a sloped plane?

    Quote Originally Posted by PijPiwo View Post
    Attach Top/Base should work. Are you sure you're selecting a curtain wall itself, not a panel or a mullion?
    Yeah, works here by actual experiment.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Sloped Bottom Plane/ Flat Top Plane
    By signalbass in forum Revit Architecture - General
    Replies: 3
    Last Post: 2010-01-06, 10:34 PM
  2. Solid sweep profile is not visible in edit mode
    By hkadani in forum Revit Structure - General
    Replies: 2
    Last Post: 2008-10-20, 08:23 PM
  3. Running AutoCAD R13 in MS-Dos Mode, set-up ALT+TAB to switch to this mode?
    By ledgeprojects103171 in forum AutoCAD Customization
    Replies: 0
    Last Post: 2006-02-26, 07:48 PM
  4. Sweep Profile plane and Orient by plane
    By dbaldacchino in forum Revit Architecture - General
    Replies: 2
    Last Post: 2006-02-03, 08:00 PM
  5. Edit Wall Profile out of Work Plane?
    By artitech in forum Revit Architecture - General
    Replies: 3
    Last Post: 2005-12-30, 04:46 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules