Results 1 to 1 of 1

Thread: Topography split issue

  1. #1
    Woo! Hoo! my 1st post
    Join Date
    2018-10
    Posts
    1
    Login to Give a bone
    0

    Default Topography split issue

    Good morning all,



    Quite new to Revit, still learning the basics.. I have a topography and I am trying to make roads that follow the topograpy. I have split the topography using the split tool and have changed the elevation so it is 150mm lower than the topography. However once i do thise there is a visible gap between the two surfaces. is there a way to fix this, by possibly thickening the surface?



    I appretiate your time in advance.



    Thanks,



    Phillipe
    Attached Images Attached Images

Similar Threads

  1. 2017: Revit Printing and Topography Issue
    By Anthony@LDG in forum Revit Architecture - General
    Replies: 3
    Last Post: 2016-05-26, 10:06 PM
  2. section view w/ split segments AND split view depths (far clip offset)
    By Ning Zhou in forum Revit Architecture - General
    Replies: 0
    Last Post: 2010-04-19, 04:25 PM
  3. Revit Bug? - Split object randomly inherits properties of a split region within it
    By Andrew Dobson in forum Revit Architecture - General
    Replies: 3
    Last Post: 2010-04-07, 12:23 PM
  4. Site - Topography issue
    By tonyisenhoff in forum Revit Architecture - General
    Replies: 3
    Last Post: 2006-01-18, 06:59 PM
  5. Split FACE tool for topography roads etc
    By Martin P in forum Revit Architecture - Wish List
    Replies: 1
    Last Post: 2004-04-01, 02:51 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •