Hi,
I have had help for a couple of AutoLISP routines in the past and I have another one that I am hoping for some help with.
When completing my drawings I have to show 'ducts' for road crossings. At the moment I manually draw a polyline where a duct is required from one point to another.
Although this is a fairly straight forward task it can be very time consuming so I am wondering if it is possible to click once on the '0gas service' polyline and then a routine will run that automatically adds a polyline on the 'duct' layer from this point along the '0gas service' line to the nearest intersecting polyline?
I have attached a drawing that shows what I am looking for.
Thanks