Results 1 to 3 of 3

Thread: objects below Z-axis

  1. #1
    100 Club tomcarver's Avatar
    Join Date
    2015-11
    Location
    Tucker, GA
    Posts
    106
    Login to Give a bone
    0

    Default objects below Z-axis

    Hello,

    99.9% of my work is 2D. Only in the X and Y-axis. Somehow, I have some objects in the negative Z-axis. I'm not sure how I did this and I'm not sure how to fix it. I noticed the problem when I saw some objects that should have been aligned but were not. I checked the distance to see how far to move them and saw that the X and Y distances were 0 but the distance in the Z-axis was 6". I further confirmed the problem by using the view cube to view the objects perpendicular to the Z-axis and saw that some were below the X-Y plane.

    Can anyone help me get these lines/objects back to the X-Y plane?

    Thanks,

    Tom

  2. #2
    Administrator Ed Jobe's Avatar
    Join Date
    2000-11
    Location
    Turlock, CA
    Posts
    6,396
    Login to Give a bone
    0

    Default Re: objects below Z-axis

    Try the FLATTEN command.

    Also, if you have an object that is -6" Z, then you can use the move command. For the second point use @ for the relative coordinate, e.g. @0,0,6
    C:> ED WORKING....

  3. #3
    I could stop if I wanted to
    Join Date
    2014-08
    Posts
    447
    Login to Give a bone
    0

    Default Re: objects below Z-axis

    HI What does the properties window say, if the x,y and z aren't greyed out simply enter zero in the properties window

Similar Threads

  1. 'Section box' in {3D} view can be rotated about X or Y axis as well as Z axis.
    By Wish List System in forum Revit Architecture - Wish List
    Replies: 0
    Last Post: 2012-02-06, 07:34 AM
  2. Replies: 6
    Last Post: 2006-10-13, 12:04 PM
  3. Lines on X axis are drawn at varying Z axis
    By s.nail in forum AutoCAD 3D (2006 or below)
    Replies: 16
    Last Post: 2006-09-20, 04:23 AM
  4. Mirror Objects Along 2 Axis....HELP..!
    By CADdancer in forum AutoLISP
    Replies: 2
    Last Post: 2004-10-01, 11:42 AM
  5. Set all objects in a selection set to 0 elvation in the Z axis
    By jagnag in forum AutoCAD 3D (2006 or below)
    Replies: 4
    Last Post: 2004-07-16, 08:18 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •