Results 1 to 1 of 1

Thread: Steel Beam and Pipe Flanges and Fittings

  1. #1
    Member
    Join Date
    2011-10
    Location
    Norfolk England
    Posts
    25
    Login to Give a bone
    0

    Default Steel Beam and Pipe Flanges and Fittings

    Hi

    This may not be the place for this as its VB based but I think its easier than the blocks route.

    Although the VB does produce a block as an insertion.
    Its handy if you are doing 3D, just explode the block and, in the case of Steel Section, use the polyline outline to stretch to 3D, and use the Flange as solid of rotation.

    Make sure you have the VB module loaded!

    Hope this helps somebody

    Cheers Geoff
    Attached Files Attached Files

Similar Threads

  1. Pipe Flanges defined at the connector, not in the Pipe type
    By Wish List System in forum Revit MEP - Wish List
    Replies: 1
    Last Post: 2016-08-05, 02:41 PM
  2. Replies: 3
    Last Post: 2015-12-05, 08:19 PM
  3. Revit pipe flanges and flanged valves
    By tim99 in forum Revit MEP - General
    Replies: 12
    Last Post: 2015-06-25, 11:17 AM
  4. Pipe and fittings w/flanges
    By SRBalliet in forum Dynamic Blocks - Sharing
    Replies: 3
    Last Post: 2011-05-08, 10:38 PM
  5. Beam Flanges over 2'-0" width not responding to Framing Elevation.
    By dlevesque in forum Revit Structure - General
    Replies: 1
    Last Post: 2007-06-19, 03:15 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •